Related Topics:
Virtual Local Area Networks-
Silicon Photonics for GPON Devices in Local Area Networks
Silicon photonics has developed rapidly in recent years, which has received widespread attention due to the fact that it can overcome the bandwidth bottleneck in optical communications. This pape.
-
Selection of Dedicated BERT Bit Error Rate Tester for Local Area Networks
Several BERT test for Ethernet and service activation methods have been developed, each with inherent advantages and limitations. While some test processes are well suited for specific application.
-
Principle of Relay Protection for Distribution Networks
Based on the principle of active power and differential current in the fault additional network, a hybrid relay protection scheme is proposed, and an independent setting scheme is proposed in the r.
-
Customization Process for Low-Noise Reconfigurable Optical Add-Drop Multiplexers for Backbone Networks
Network operators diversify service offerings and enhance network efficiency by leveraging bandwidth-variable transceivers and colorless flexible-grid reconfigurable optical add-drop multiplexers (RO.
-
The role of IP addresses in VLANs of a Layer 3 network core switch
These VLAN interfaces act like router interfaces, with an IP address and mask. The Layer 3 switch has an IP routing table, with connected routes off each of these VLAN interfaces. A. In this sample chapter from CCNA 200-301 Official Cert Guide, Volume 1, Wendell Odom discusses the configuration and verification steps related to three methods of routing between VLANs with three major sections: VLAN Routing with Router 802. 1Q Trunks, VLAN Routing with Layer 3 Switch SVIs, and. Normally, Routers are used to divide the broadcast domain and switches (at layer 2) Operate in a single broadcast domain but Switches can also divide the broadcast domain by using the concept of VLAN (Virtual LAN).